REXROTH EcoDrive Cs - Default Chapter; Table of Contents

Rexroth EcoDrive Cs Drives Contents I
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
Contents
1 Introduction to the System 1-1
1.1 Rexroth EcoDrive Cs Drive System.............................................................................................. 1-1
1.2 Rexroth EcoDrive Cs Device Range ............................................................................................ 1-2
Individual Components............................................................................................................ 1-2
Configuration ........................................................................................................................... 1-2
1.3 Drive Controller – Motor Combinations ........................................................................................1-4
1.4 Type Codes .................................................................................................................................. 1-5
Drive Controllers with Analog/Parallel Interface...................................................................... 1-5
Drive Controllers with SERCOS interface ............................................................................... 1-6
Drive Controllers without Master Communication (Basic Devices)......................................... 1-7
Master Communication............................................................................................................1-8
2 Important Directions for Use 2-1
2.1 Appropriate Use............................................................................................................................ 2-1
Introduction.............................................................................................................................. 2-1
Areas of Use and Application .................................................................................................. 2-2
2.2 Inappropriate Use ......................................................................................................................... 2-2
3 Safety Instructions for Electric Drives and Controls 3-1
3.1 Introduction ................................................................................................................................... 3-1
3.2 Explanations ................................................................................................................................. 3-1
3.3 Hazards by Improper Use............................................................................................................. 3-2
3.4 General Information...................................................................................................................... 3-3
3.5 Protection Against Contact with Electrical Parts........................................................................... 3-5
3.6 Protection Against Electric Shock by Protective Low Voltage (PELV)......................................... 3-6
3.7 Protection Against Dangerous Movements .................................................................................. 3-7
3.8 Protection Against Magnetic and Electromagnetic Fields During Operation and
Mounting ....................................................................................................................................... 3-9
3.9 Protection Against Contact with Hot Parts.................................................................................. 3-10
3.10 Protection During Handling and Mounting.................................................................................. 3-10
3.11 Battery Safety ............................................................................................................................. 3-11
3.12 Protection Against Pressurized Systems.................................................................................... 3-11
4 Technical Data (Drive Controllers) 4-1
4.1 Dimensional Drawings.................................................................................................................. 4-1
DKC01.3-0xx Drive Controllers with Analog/Parallel Interface ............................................... 4-1
DKC02.3-004 (100 W), DKC02.3-008 (200 W) and DKC02.3-012 (400 W) Drive
Controllers with SERCOS interface......................................................................................... 4-2
DKC02.3-018 (750 W) Drive Controller with SERCOS interface ............................................ 4-3
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com