REXROTH EcoDrive Cs - DKC10.3-018 (750 W) Drive Controller - Basic Device

Rexroth EcoDrive Cs Drives Technical Data (Drive Controllers) 4-5
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
DKC10.3-018 (750 W) Drive Controller – Basic Device
maszblatt_94.fh7
22
(94)
5.2
70 24
182
160
172
11
5
50
50
170
22
5.2
2.5
LISTED 7Z45
E164620
R
DANGER
Read the manual and follow the safety instructions before use. Where residual-current-operated protective device(RCD) is used for protection in case of direct or indirect contact,only RCD of Type B is allowed on the supply side of this Electronic Equipment(EE). Never fail to connect Protective Earth(PE) terminal. 65/75í Wire Only. Use Copper Conductors Only. Refer to Manual for Wiring and Wire Size. Refer to Manual for Over Load Protection.
Do not touch heatsink when power is ON. Risk of burn.
Hazardous Voltage
High Temperature
Do not touch terminals within 10 minutes after disconnect the power. Risk of electric shock.
Design notice
QR
DKC10.3-001-3-MGP-01VRS Rexroth Indramat GmbH
Made in Japan123456
200W
0-333.3Hz 50/60Hz
1.5A 1.1A
3 3
37V 200-230V
OUTPUT INPUT
Power
Freq.
F.L.C
Phase
Voltage
K40/02
123456-F0001
SN123456-F0001
A15
X4
X5
X6
W
V
U
RB2
RB3
RB1
DL2
DL1
L2C
L1C
L3
L2 L1
9
8
7
6
5
4
3
2
1
9
8
7
6
5
4
3
2
1
ADDRESS
NODE
0 0
S1
H1
S2
S3
LINE ERROR
Cs
ECODRIVE
Rexroth
X4
X5_3 X5_2 X5_1
INPUTíF200V-240V
X3 X2 X1
X6
Fig. 4-5: DKC10.3-018 (750 W) drive controller – basic device
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com