REXROTH EcoDrive Cs - DKC10.3-004 (100 W), DKC10.3-008 (200 W) and DKC10.3-012 (400 W) Drive Controllers - Basic Devices

4-4 Technical Data (Drive Controllers) Rexroth EcoDrive Cs Drives
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
DKC10.3-004 (100 W), DKC10.3-008 (200 W) and DKC10.3-012 (400 W)
Drive Controllers – Basic Devices
maszblatt_79.fh7
170
14.5
14.5
79()
5.2
55 24
182
160
172
11
5
50
50
5.2
2.5
A15
SN123456-F0001
123456-F0001
K40/02
Voltage
Phase
F. L. C
Freq.
Power
INPUT OUTPUT
200-230V 37V
3 3
1.1A 1.5A
50/60Hz 0-333.3Hz
200W
123456 Made in Japan Rexroth Indramat GmbH DKC10.3-001-3-MGP-01VRS
QR
Design notice
Do not touch terminals within 10 minutes after disconnect the power. Risk of electric shock.
High Temperature
Hazardous Voltage
Do not touch heatsink when power is ON. Risk of burn.
Read the manual and follow the safety instructions before use. Where residual-current-operated protective device(RCD) is used for protection in case of direct or indirect contact,only RCD of Type B is allowed on the supply side of this Electronic Equipment(EE). Never fail to connect Protective Earth(PE) terminal. 65/75í Wire Only. Use Copper Conductors Only. Refer to Manual for Wiring and Wire Size. Refer to Manual for Over Load Protection.
DANGER
R
E164620
LISTED 7Z45
X4
X5
X6
W
V
U
RB2
RB3
RB1
DL2
DL1
L2C
L1C
L3
L2 L1
9
8
7
6
5
4
3
2
1
9
8
7
6
5
4
3
2
1
ADDRESS
NODE
0 0
S1
H1
S2
S3
LINE ERROR
Cs
ECODRIVE
Rexroth
X4
X5_3 X5_2 X5_1
INPUTíF200V-240V
X3 X2 X1
X6
Fig. 4-4: DKC10.3-004 (100 W), DKC10.3-008 (200 W) and DKC10.3-012
(400 W) drive controllers – basic devices
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com