REXROTH EcoDrive Cs - DKC02.3-004 (100 W), DKC02.3-008 (200 W) and DKC02.3-012 (400 W) Drive Controllers with SERCOS Interface

4-2 Technical Data (Drive Controllers) Rexroth EcoDrive Cs Drives
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
DKC02.3-004 (100 W), DKC02.3-008 (200 W) and DKC02.3-012 (400 W)
Drive Controllers with SERCOS interface
maszblatt_55.fh7
5.2
2.5
HIGH
LOW
ON
ON
OFF
ON
OFF
ON
OFFOFF
21
TRANSMITTER
POWER
RX
TX
X20
S20
X21
DANGER
Read the manual and follow the safety instructions before use. Where residual-current-operated protective device(RCD) is used for protection in case of direct or indirect contact,only RCD of Type B is allowed on the supply side of this Electronic Equipment(EE). Never fail to connect Protective Earth(PE) terminal. 65/75í Wire Only. Use Copper Conductors Only. Refer to Manual for Wiring and Wire Size. Refer to Manual for Over Load Protection.
Do not touch heatsink when power is ON. Risk of burn.
Hazardous Voltage
High Temperature
Do not touch terminals within 10 minutes after disconnect the power. Risk of electric shock.
Design notice
R
QR
E164620
DKC02.3-001-3-MGP-01VRS Rexroth Indramat GmbH
Made in Japan123456
200W
0-333.3Hz 50/60Hz
1.5A 1.1A
3 3
37V 200-230V
OUTPUT INPUT
Power
Freq.
F.L.C
Phase
Voltage
K40/02
123456-F0001
SN123456-F0001
A15
LISTED 7Z45
TX
RX
S20
2
1
ON
X4
X5
X6
W
V
U
RB2
RB3
RB1
DL2
DL1
L2C
L1C
L3
L2 L1
9
8
7
6
5
4
3
2
1
9
8
7
6
5
4
3
2
1
ADDRESS
NODE
0 0
Rexroth
ECODRIVE
Cs
S1
H1
S2
S3
LINE ERROR
X20
X21
X4
X5_3 X5_2 X5_1
INPUTíF200V-240V
X3 X2 X1
X6
5172
27.5
55
27.5
182 160 11
5.2
170
Fig. 4-2: DKC02.3-004 (100 W), DKC02.3-008 (200 W) and DKC02.3-012
(400 W) drive controllers with SERCOS interface
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com