REXROTH SYNAX200 - Configuration Example with PPC; Commissioning the PPC Link; General Information

9-4 PPC Link SYNAX200
DOK-SYNAX*-SY*-07VRS**-PR01-EN-P
9.4 Configuration Example with PPC
With an eye towards increased machine availability PPC motion controls
can become an own 24V electronic storage. So they can be supported as
with master system UPS = uninterruptable power source.
SYNAX ring 3SYNAX ring 1 SYNAX ring 2
DAQ
RECO
DAQ
RECO
DAQ
RECO
PPC PPC PPC
link ring
ARCNET
SY7PR088.FH7
DAQ
Fig. 9-6: Double ring configuration with PPC
9.5 Commissioning the PPC Link
General Information
Each PPC needs a different link address. The link address is set with
parameter "PPC link - address" (C-0-0179).
The PPC link is parametrized via SynTop. An active PPC link is displayed
on the DAQ03 using the H11 or H12 display.
The optical transmission power of the primary or secondary rings is
parametrized using SynTop.
Using the distortion display of the DAQ (DAQ03.1R: LEDs H17 or H18) it
is possible to check the quality of the optical receive signal.
Link address
Parametrization
Setting optical transmission
power
Distortion display