2000/3000 SHEET FINISHERS (B700/B701)
B132/B200 1-72 SM
Support Tray
Take the following steps if the "Exit Tray Full" message displays even though the
exit tray is not full. (The message is caused by the trailing edges of excessively
curled paper activating the tray full sensor [A] before the tray is actually full.)
1. Remove the paper form the paper feed tray, turn it upside down, then print.
2. If Step 1 does not solve the problem, place the support tray [B] on the exit tray
with the >PP< mark positioned as shown at [C].
3. If Step 2 does not solve the problem, place the support tray on the exit tray with
the >PP< mark positioned as shown at [D].
>PP<
>PP<
B700I110.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
