PUNCH UNIT (B702)
SM 1-75 B132/B200
Installation
1.10.2 INSTALLATION
1. If the finisher is connected to the copier, disconnect the power connector [A]
and move the finisher away from the copier.
2. Remove the rear cover [B] ( x 2) and open the front door.
NOTE: At the bottom of the rear cover, make sure to disconnect the tabs that
attach the cover to the frame.
3. Remove the guide plate [C] ( x 2).
4. Move the punch unit [D] along its rails into the finisher. Make sure that the pin
engages correctly at the front and rear.
5. Connect and attach the punch unit [E] ( x 2, x 1).
• The cables [F] are coiled and attached to the PCB.
• Attach connectors to CN601 and CN602.
B702I102.WMF
B702I103.WMF
[A]
[B]
[C]
[D]
[E]
Rear
Front
[F]
To Next Page
Loading...
