Ricoh B132 - Enabling Booklet Binding (B700 Only); Selecting the Staple Supply Name

2000/3000 SHEET FINISHERS (B700/B701)
SM 1-73 B132/B200
Installation
Selecting the Staple Supply Name
Go into the SP mode and input this information.
5841 Supply Name Setting
These names show when the user prints the Inquiry List
Push the Counter key, then push ‘Print Inquiry List’.
Push the Inquiry button on the initial User Tools screen.
013 Staple Std3
Input the name of the staples that are used for standard
stapling (not booklet stapling). This setting should be
done for the B700 and B701.
022 Staple Bind2
Input the name of the staples that are used for booklet
stapling (saddle-stitching). This setting is necessary only
for the B700.
Enabling Booklet Binding (B700 Only)
To enable booklet binding (saddle-stitching) for the B700, you must select the
center stapling position.
1. Push the User Tools key.
2. Touch “Copier/Document Server Features”.
3. Touch the “Input/Output” tab.
4. Touch a “Stapling Position” button and touch the center (saddle-stitch) stapling
symbol.
5. Go out from the User Tools mode. Set the number of copies, touch the center
stapling symbol on the operation panel, then start the print job.