COPIER B132/B200
SM 1-35 B132/B200
Installation
Counter Display Setting
The default setting for the counter is "0" (development). Do the SP setting below to
set the counter for copy/print (paper count).
1. Enter the SP mode.
2. Do SP5045 001 (Counter Display Setting).
3. Select the counter to use:
0
Development counter (Default)
1 Page counter
Important!
• THIS SETTING CAN BE DONE ONLY ONCE. AFTER IT IS SET TO "1", THE COUNTER
SETTING CANNOT BE CHANGED
. IF THE WRONG SETTING IS SELECTED BY MISTAKE,
CONTACT YOUR TECHNICAL SUPERVISOR.
Print an SMC Report
1. Go into the SP mode.
2. Do SP5990 001 to print a full SMC report. Keep it in a safe location, with the
factory setting sheet.
To Next Page
Loading...
