Ricoh B132 - Copier Output Check: Sp5804

COPIER INPUT/OUTPUT CHECK
B132/B200 5-198 SM
5.6.2 COPIER OUTPUT CHECK: SP5804
1. Open SP mode 5804.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table on the next page.)
3. Press On then press Off to test the selected item.
NOTE: You cannot exit and close this display until you press off to switch off
the output check currently executing. Do not keep an electrical
component switched on for a long time.
5804 Output Chk Output Check
001 Fuse Fan: Front NS 045 Hopper Mtr Fwd
002 Fuse Fan: Front HS 046 P.Pump Drv CL:Y
003 Fuse Fan: Back NS 047 P.Pump Drv CL:M
004 Fuse Fan: Back HS 048 P.Pump Drv CL:C
005 Opt. Fan: Front NS 049 P.Pump Drv CL:K
006 Opt. Fan: Front HS 050 Used Toner Mtr 1
007 Opt. Fan: Back NS 051 Used Toner Mtr 1
008 Opt. Fan: Back HS 052 Chage dc:Y
009 Exit Pipe Fan 053 Chage dc:M
010 Sub Fuse Fan: NS 054 Chage dc:C
011 Sub Fuse Fan: HS 055 Chage dc:K
012 PT Fan: NS 056 Chage ac:Y
014 Dupx Fan: NS 057 Chage ac:M
015 Dupx Fan:Front:NS 058 Chage ac:C
016 Dupx Fan:Front:HS 059 Chage ac:K
017 Dupx Fan:Back:NS 060 Dev dc:Y
018 Dupx Fan:Back:HS 061 Dev dc:M
019 Exit Fan:NS 062 Dev dc:C
021 PCB Box Fan1:NS 063 Dev dc:K
023 PCB Box Fan2:NS 064 Dev ac:Y
025 PSU Fan 1:NS 065 Dev ac:M
026 PSU Fan 1:HS 066 Dev ac:C
027 PSU Fan 2:NS 067 Dev ac:K
028 PSU Fan 2:HS 068 Paper Transfer
029 PT Fan 1:NS 069 Paper Separate dc
030 PT Fan 2:NS 070 Paper Separate ac
031 Pelt. Cool Fan:NS 099 ID Sensor:3c
032 Pelt. Cool Fan:HS 100 ID Sensor: K
033 Potential Sn Fan 101 QL:Y
034 Ozone Fan 102 QL:M
035 PCU Fan:Y 103 QL:C
036 PCU Fan:C 104 QL:K
037 PCU Fan:M 105 LD:Y
038 PCU Fan:K 106 LD:M
039 Pelt. Cooling Fan 107 LD:C
040 Pelt. Cir. Fan 108 LD:K
041 Sub Hopper CL:Y 109 Polygon Mtr
042 Sub Hopper CL:M 110 Feed Mtr 1:Fwd/Nor
043 Sub Hopper CL:C 111 Feed Mtr 1:Fwd/Hi
044 Sub Hopper CL:K 112 Feed Mtr 1:Fwd/Haf