Ricoh B132 - SC Codes Group 2: Exposure

SERVICE CALL CONDITIONS
SM 4-29 B132/B200
SC codes Group 2: Exposure
Polygon motor error 1: ON timeout
SC202 D
The polygon mirror motor does
not reach the targeted operating
speed:
• Within 10 seconds after
turning on.
• Within 10 sec. after changing
speed
• Harness to polygon motor driver board
disconnected, defective
• Polygon motor defective
• Polygon motor driver board defective
• Polygon motor defective.
Polygon motor error 2: OFF timeout
SC203 D
The polygon mirror motor does
leave the READY status within
10 seconds after the polygon
motor switches off.
• Harness to polygon motor driver board
disconnected, defective
• Polygon motor defective
• Polygon motor driver board defective
• Polygon motor defective.
Polygon motor error 3: XSCRDY signal error
SC204 D
The SCRDY_N signal goes
HIGH (inactive) while the laser
diode is firing.
• Harness to polygon motor driver board
disconnected, defective
• Polygon motor defective
• Polygon motor driver board defective
Polygon motor error 4: XSCRDY signal unstable
SC205 D
When the polygon motor
switches on, or after the speed
of the motor changes, the
SCRDY_N signal goes HIGH
(inactive).
• Harness to polygon motor driver board
disconnected, defective
• Polygon motor defective
• Polygon motor driver board defective
SC210 D
Laser beam detection error 1: K (Black)
SC211 D
Laser beam detection error 1: Y (Yellow)
SC212 D
Laser beam detection error 1: M (Magenta)
SC213 D
Laser beam detection error 1: C (Cyan)
The laser synchronization sensor
failed to detect the beginning and end
of the laser beam flash for the
designated color onto the polygon
mirror while the mirror is rotating at
the prescribed number of revolutions.
• Laser synchronization
detector sensor connection
loose, not connected
• Laser synchronization
detector sensor defective