Ricoh B132 - Pcu; Developer Replacement

PCU
SM 3-41 B132/B200
Replacement &
Adjustment
3.5 PCU
3.5.1 DEVELOPER REPLACEMENT
1. Spread some paper on a flat surface to hold developer that will be dumped
from the development unit.
2. Remove the toner hopper and faceplate. (!3.2.7)
3. Remove the PCU stand [A] from bottom of the machine.
4. From the bottom of the PCU stand, remove the long special tool [B] and gear
lock [C].
5. Lay the PCU stand [A] on a flat surface.
6. Remove the PCU. (!3.2.7)
7. Position the front and rear of the PCU [D] so it matches the F (front) and R
(rear) markings on the stand, then place the PCU on the stand.
Important:
• The front-rear alignment aligns the shape of the stand with the contours of
the PCU bottom. This ensures that the exposed drum on the bottom of the
PCU is completely protected during servicing.
B132R220.WMF
F
R
B132R214.WMF
[A]
[B]
[C]
[A]
[D]