Ricoh B132 - SC Codes Group 7: Peripherals

SERVICE CALL CONDITIONS
SM 4-57 B132/B200
SC codes Group 7: Peripherals
Original pickup operation error
SC701 D
Even though the pickup motor is rotating
clock-wise, the pickup roller home position
sensor cannot detect the position of the
pickup roller.
• Pickup roller HP sensor
harness loose, disconnected,
defective
• Pickup roller HP sensor
defective
• Pickup motor harness loose,
disconnected, defective
• Pickup motor defective
• ARDF control board
defective
ARDF bottom plate lift motor
SC705 D
• The bottom plate HP sensor
did not detect the home
position of the bottom plate
after the bottom plate lift
motor switches on and lowers
the bottom plate.
• The bottom plate position
sensor does not detect the
position of the plate after the
lift motor switches on and
raises the bottom plate.
• ARDF feed motor disconnected,
defective
• Bottom plate HP sensor disconnected,
defective
• ARDF main board defective
Finisher lower transport motor error
SC720 D
No encoder pulse signal is
detected for the transport motor
within the prescribed time.
The 1st failure issues an original
jam message, and the 2nd
failure issues this SC code.
• Lower transport motor disconnected,
defective
• Finisher connection to transport motor
loose, defective
• Lower transport motor defective
• Finisher main board defective
Finisher jogger motor error
SC721 B
The jogger fences move out of
the home position but the HP
sensor output does not change
within the specified number of
pulses. The 1st failure issues an
original jam message, and the
2nd failure issues this SC code.
• Jogger HP sensor disconnected,
defective
• Jogger motor disconnected, defective
• Jogger motor overloaded due to
obstruction
• Finisher main board and jogger motor
connection loose, defective
• Finisher main board defective