EasyManua.ls Logo

Ricoh B132 - Page 458

Ricoh B132
1079 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE CALL CONDITIONS
B132/B200 4-58 SM
Finisher feed-out motor
SC723 B
The stack feed-out belt HP
sensor does not activate within
the specified time after the stack
feed-out belt motor turns on. The
1st detection failure issues a jam
error, and the 2nd failure issues
this SC code.
Stack feed-out HP sensor disconnected,
defective
Feed-out motor disconnected, defective
Finisher main board connection to feed
out motor disconnected, defective
Motor overload due to obstruction
Finisher stapler hammer motor error
SC724 D
Stapling does not finish within
the prescribed time after the
staple hammer motor turns on.
The 1st detection failure issues
a jam error, and the 2nd failure
issues this SC code.
Stapler hammer motor overloaded due to
obstruction, jammed staple, number of
sheets exceeds limit for stapling
Stapler hammer motor disconnected,
defective
Staple hammer motor HP sensor
disconnected, defective
Finisher exit guide plate motor error
SC725 D
After moving away from the
guide plate position sensor, the
exit guide is not detected at the
home position within the
prescribed time. The 1st
detection failure issues a jam
error, and the 2nd failure issues
this SC code.
Guide plate motor disconnected,
defective
Guide plate motor overloaded due to
obstruction
Guide plate position sensor
disconnected, defective
Shift jogger motor 1 error
SC726 B
The sides fences do not retract
within the prescribed time after
the shift jogger motor switches
on. The 1st detection failure
issues a jam error, and the 2nd
failure issues this SC code.
Shift jogger motor disconnected,
defective
Shift jogger motor overloaded due to
obstruction
Shift jogger HP sensor disconnected,
defective
Shift jogger motor 2 error
SC727 B
The side fences do not retract
within the prescribed time after
the shift jogger motor switches
on. The 1st detection failure
issues a jam error, and the 2nd
failure issues this SC code.
Motor harness disconnected, loose,
defective
Motor defective
Motor overload
HP defective

Table of Contents

Related product manuals