SERVICE PROGRAM MODE
B132/B200 5-2 SM
To Enter and Exit the Service Mode
1. Press the [Clear Modes] ()key.
2. On the operation panel keypad, press "107".
3. Hold down the Clear/Stop () key for more than 3 seconds.
The Copy SP or PM Counter items are displayed. If the printer or
scanner/printer option is installed, the Printer SP and Scanner SP items are
also displayed.
To enter normal Copy SP mode, touch “Copy SP”.
4. When you are finished, press “Exit” to exit the SP mode, then press again to
return to the Copier Window.
To Switch to the Copy Window for Test Printing
1. In the SP mode display, touch "Copy Window" to switch to the copy operation
screen when you need to select paper for a test print.
2. Use the copy window (copier mode) to select the appropriate settings (paper
size, etc.) for the test print.
3. Press the [Start] () key to execute the test print.
4. Touch "SP Mode" (highlighted) to return to the SP mode screen and repeat
from step 1.
Using the SP Mode
SP command numbers can be entered directly (if you know the number) or the
command can be selected from the menus.
Direct Entry
SP5831 an executable SP that initializes the User Tools settings, can be executed
immediately by just entering the numbers.
1. On the keypad press "5831".
2. Press [#] (Enter).
3. Touch “Execute” on the touch panel.
If you know all seven digits of the SP code, enter the seven numbers and press
Execute.
If you do not know all the numbers, enter only the first four numbers of the seven-
digits and press [#]. The display goes immediately to the first SP of that group.
Then you can use the buttons to browse to the desired selection.
To Next Page
Loading...
