Ricoh B132 - Download Error Codes

PROGRAM DOWNLOAD
B132/B200 4-2 SM
4.1.3 DOWNLOAD ERROR CODES
Display Details Recovery
Controller ROM update error 1 01 Reboot after
card insert E01
↕
Module ID
Card No. xx/xx
When the update break data is stored in
NVRAM, the break module information and
the decompression module capable of
writing do not match.
• Use the correct card
Controller ROM update error 2. 02 Download Error E02
Power off/on
Error occurs during ROM update program
initialization.
• Cycle the machine
off/on to rewrite
Controller ROM update error 3 03 Download Error E03
Power off/on
The ROM for the write operation does not
exist.
• Cycle the machine
off/on
• Install the missing ROM
DIMM
Controller ROM update error 4 04 Download Error E04
Power off/on
GZIP data confirmation fails. (CRC value
check)
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller board
Controller ROM update error 5 05 Download Error E05
Power off/on
Error occurs when writing to the device.
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller board
Controller ROM update error 6 06 Download Error E06
Power off/on
CPU clock error.
• Turn the machine power
off/on.
• Set controller DIPSW-1
to ON to force the
machine to write to
ROM.
• If you cannot force the
machine to write,
replace the controller
board.
Controller ROM update error 7 19 Download Error E19
Power off/on
Schedule data is unclear.
• Software defective
System error 1 (+SC991) 20 Down Error E20
Power Off/On
The physical address cannot be mapped.
Software/hardware is defective
• Cycle the machine
off/on and re-try
• Replace controller board
System error 2 (+SC991) 21 Download Error E21
Power Off/On
There is not sufficient memory to
download.
• Cycle the machine
off/on and re-try.
• Replace RAM
• Replace the controller
board