Ricoh B132 - Installation

MFP CONTROLLER OPTIONS
SM 1-123 B132/B200
Installation
Installation
WARNING!
Turn the machine off and disconnect the machine power cord before you
start this procedure.
NOTE: For the printer/scanner unit, the machine must have a minimum of 128 MB
of memory (more is recommended). Memory chips are not supplied with
this option.
1. Disconnect the ARDF cable [A] (
x1).
2. Remove the controller board [B] ( x3).
3. Connect the SDRAM DIMM (128 MB expansion memory) into RAM slot CN501
on the controller board.
4. Attach the controller board ( x3).
5. Remove the I/F Slot Cover E [C] ( x2).
6. Install the Interface Unit Board [D] (NIC/USB) B763 in Slot E.
7. Remove the SD card slot cover [E] ( x2)
8. Install the Printer/Scanner SD card [F] in SD Card Slot 2 (middle slot).
9. Attach the SD card slot cover ( x2).
B132I710.WMF
B737I107.WMF
[A]
[B]
[C]
[D]
[E]
[F]