SERVICE PROGRAM TABLES
B132/B200 5-20 SM
5.5 SERVICE PROGRAM TABLES
5.5.1 SERVICE TABLE KEY
Notation What it means
[range/step] Example: [–9~+9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen in
the “Initial” box immediately below the entry box. Some of the default
settings for the B064 Series and B140 Series are slightly different, so be
sure to check the “Initial” box on the SP mode screen.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
LEF Long Edge Feed
SEF Short Edge Feed
To Next Page
Loading...
