SERVICE PROGRAM TABLES
B132/B200 5-132 SM
Group 6000
6006 ADF Reg Adj ADF Registration Adjustment
001 ADF Main Reg Adj
Adjusts the side-to-side registration for the front/back in ADF
mode.
[–3~+3/0.1 mm]
003 ADF Sub Reg Adj
Adjusts the vertical registration for the front/back in ADF
mode.
[–30 ~+30/0.17 mm]
-30 = -5.1 mm
+30 = +5.1 mm
005 ADF Buck Adj:Front
Adjusts the roller timing at the skew correction
sensor/entrance roller. A higher setting causes more
buckling.
[–12.0~+12/0.25 mm]
-12 = -3.0 mm
+12 = +3.0 mm
006 ADF Buck Adj:Back
Adjusts the roller timing at the interval sensor/scanning roller.
A higher setting causes more buckling.
[–8.0~+8/0.25 mm]
[–8.0~+8/0.25 mm]
-8 = -2 mm
+8 = +2 mm
007 ADF TEdge EMargin
These settings adjust the erase margin for the trailing edges
for the front/back.
[–20~+20/0.5 mm]
-20 = -10 mm
+20 = +10 mm
6007 ADF Input Chk ADF Input Check
Displays signals received from sensors and switches in the ADF. (!5.7.1)
6008 ADF Output Chk ADF Output Check
Turns on the ADF electrical components individually for testing. (!5.7.2)
6009 ADF Free Run ADF Free Run
This SP does an ADF free run in duplex original mode.
001 Simplex
002 Duplex
6016 ADF OrgSizePrior ADF Original Size Detection Priority
Allows selection of alternate settings for automatic original size detection. (!6.4.3)
6017 ADF Mag Adj ADF Magnification Adjustment
001 ADF Sub Mag Adj
This changes the magnification by adjusting the speed of
scanning.
[–50(–5%)~+50(+5%)/0.1%]
To Next Page
Loading...
