SERVICE PROGRAM TABLES
SM 5-133 B132/B200
Service Tables
6020 ADF Skew Adj ARDF Skew Adjustment at the Scanning Entrance Roller
This SP switches on stopping the scanning entrance roller for all paper sizes.
Normally, the scanning entrance roller stops briefly to correct skew of small paper
sizes in the ADF paper path and for the 2nd side scanning of originals during
duplexing. Setting this SP to "1" sets the ADF to stop the scanning entrance roller for
all paper sizes to correct for skew a second time.
[0~1/1]
6050 Adj Staple Pos Staple Position Adjustment
Adjusts the position of the staples during corner stapling.
6090 LCT Output Chk LCT Output Check
Performs the output check for the optional LCT.
001 LCT Feed Motor
002 LCT Pickup SOL
6101 Adj Punch Pos 1 Punch Position Adjustment
Adjusts the punch hole positions in the direction of paper feed.
NA: North America
DOM: Japan
EU: Europe
SCAN: Scandinavia
001
2-Hole:DOM
002
3-Hole:NA
003
4-Hole:EU
004
4-Hole:SCAN
005
2-Hole:NA
[-75~+75/0.5 mm]
+ Value: Shifts punch unit in the direction of feed.
- Value: Shift punch unit against direction of feed.
Paper Feed
B132S921.WMF
To Next Page
Loading...
