COVER INTERPOSER TRAY (B704)
B132/B200 1-104 SM
Preparing the Finisher (B700/B701/B706)
1. Remove the cover [A] of the relay connector.
2. Loosen the screw of the bracket [B] ( x 1) then remove the bracket.
3. Remove the guide plate [C]. (You will attach this guide plate to the cover
interposer. Do not discard it.)
Important: If you will install the cover interposer tray on a B700/B701/B706
finisher that was installed on the machine before this time, remove the sponge
strip from the finisher. Keep this strip, because you will attach it later to the
interposer tray.
4. If you will install the B700/B701, attach the extensions to the finisher without
modification. Go to "Attaching the Extensions for the B700/B701" on page 1-
108.
-or-
If you will install the B706, modify the extensions and attach them to the
finisher. Go to "Attaching the Extensions for the B706" on page 1-105.
B704I103.WMF
[A]
[B]
[C]
To Next Page
Loading...
