MFP CONTROLLER OPTIONS
B132/B200 1-120 SM
Undo Exec
1. Turn the main switch OFF.
2. Put the SD card with the merged applications in SD Card Slot 2.
3. Put the original destination SD card (the one stored in the front door) into Slot 3.
NOTE: The SD card in Slot 3 must be the original SD card of the application
you want to move from Slot 2 to Slot 3. You cannot use any blank SD
card in Slot 3.
4. Turn the main switch ON.
NOTE: Do Not Open the Door!!
5. Go into the SP mode and do SP5873-002 (Undo Exec)
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch OFF.
8. Remove the SD cards from the slots.
9. Turn the main switch ON.
To Next Page
Loading...
