Ricoh B132 - Image Transfer Unit; Disassembly and ITB Replacement; Itb, Belt Cleaning Unit

IMAGE TRANSFER UNIT
SM 3-75 B132/B200
Replacement &
Adjustment
3.8 IMAGE TRANSFER UNIT
3.8.1 ITB, BELT CLEANING UNIT
Disassembly and ITB Replacement
1. Put a clean sheet of paper on a flat surface.
2. Remove the ITB unit from the machine (!3.2.8). Put the ITB unit on the sheet
of paper.
NOTE: Keep the unit flat when you remove it, lift it, carry it, and put it down.
Otherwise, waste toner will spill out, and will spill inside the unit, and
this can cause copying problems.
3. Disconnect the image transfer belt unit connector and screw [A] ( x1,  1x)
4. Push the image transfer unit to the rear to disengage the front pins [B].
5. Pull the unit to the front to disengage the rear pin [C].
6. Lift the image transfer unit to separate it from the belt cleaning unit [D].
B132R310.WMF
[A]
[B]
[C]
[D]