PUNCH UNIT (B702)
SM 1-77 B132/B200
Installation
12. At the front, use a pair of wire cutters to remove the part [A] of the cover.
13. Install the punch-waste transport unit [B] in the finisher.
NOTE: Make sure that the punch-waste transport unit moves smoothly on its
rails. If it does not, make sure that the rails are aligned with the grooves.
14. Remove the short connector from the connector [C].
NOTE: This is the 4-pin connector.
15. Connect the cable and attach the punch-waste transport unit
( x 1, x 1, x 1).
16. Set the hopper [D] in its holder.
B702I106.WMF
B702I107.WMF
[A]
[B]
[D]
4-pin Connector
[C]
To Next Page
Loading...
