PUNCH UNIT B531/A821
SM 1-97 B132/B200
Installation
10. At the rear of the rear of the finisher, put the punch unit [A] in the finisher.
11. At the front, attach the punch unit [B] with the large step screw ( x 1, M4 x 10).
12. At the rear, attach the 2 mm spacer [C] and attach the screws [D] to the punch
unit ( x 2, M4 x 10).
NOTE: At the hole immediately above the lock lever, use one of the screws
from the paper guide removed above to attach the remaining two
spacers to the frame. These two spacers are used to adjust the
horizontal position of the punch holes.
13. At the front, attach the punch unit knob [E] ( x 1).
B531I006.WMF
B531I005.WMF
[D]
[B]
[C]
[A]
[E]
To Next Page
Loading...
