COMMON REMOVAL PROCEDURES
SM 3-19 B132/B200
Replacement &
Adjustment
7. Slowly and carefully pull the image transfer unit [A] out of the machine.
Important!
• Remove carefully. The ITB unit is
heavy and not attached to the rails
with screws.
• To prevent toner scattering inside
and outside the unit, keep the unit
[B] flat when you remove it, lift it,
carry it, and put it down.
• Never stand the ITB unit [C] on its
edge before you remove the
cleaning unit from the ITB (! 3.8.1).
• Never place the ITB unit on a carpet
where toner may scatter or the unit
will collect dust.
Reinstallation
• Re-insert the image transfer unit slowly and carefully to avoid snagging the belt
on the frame of the machine.
• Make sure that the image transfer unit does not snag on the toner cap of the
yellow PCU on the far left.
1
B132R309.WMF
B132R309B.WMF
[A]
[B]
[C]
To Next Page
Loading...
