LASER UNIT
SM 3-37 B132/B200
Replacement &
Adjustment
Remove:
[A]: Left plate ( x4)
[B]: Right plate ( x4)
[C]: Ground wire ( x1)
[D]: Cross piece ( x4)
Before going to the next step,
disconnect the connector [*].
[E]: Detach the support rod from the
rubber clamps.
[F]: Raise the scanner unit. ( x 2)
[G]: Set the support rod at the base
% then under the front, right
corner & of the scanner unit.
CAUTION
The scanner unit is very heavy. Never remove the support rod during
servicing.
Reinstallation
• Be sure to reconnect ground wire [C].
B132R001.WMF
1
2
B132R002.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[*]
To Next Page
Loading...
