PCU
B132/B200 3-48 SM
30. Re-install the development unit in the PCU.
31. Reattach the small and large plate at the front and rear.
32. Push the PCU fully into the slot to reinstall it.
33. To release the developer in the PCU,
pull out the film seal [A].
NOTE: Place your other hand on the
PCU [B] to steady it while you pull on
the film seal.
Reinstallation
Important! YOU MUST DO SOME SPS, OR A FATAL ERROR WILL OCCUR. (!3.5.7)
B132I101.WMF
[A]
[B]
To Next Page
Loading...
