COPIER B132/B200
B132/B200 1-10 SM
1. Open the front door and, and remove the transfer belt release lever [A](1 tape).
We will install this in the correct location later.
IMPORTANT!
• DO NOT TOUCH [B], [C], OR [D] AT THIS TIME. THESE ITEMS ARE REMOVED AFTER YOU
REMOVE THE FACEPLATE
.
• T
O PREVENT DAMAGE TO THE ITB, NEVER TURN DOWN LEVER [D] TO PULL OUT THE DRAWER
UNIT UNTIL AFTER YOU HAVE REMOVED THE ROD
WITH THE RED TAG AND WIRE [B]. THE
DRAWER MUST REMAIN INSIDE THE MACHINE UNTIL AFTER THE DEVELOPER IS INSTALLED IN
THE DEVELOPER CARTRIDGES OF THE
PCUS.
• T
HE ROD IS REMOVED AFTER THE FACE PLATE IS REMOVED TO INSTALL THE DEVELOPER
CARTRIDGES. (!PG.1-12)
B132I005.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
