SERVICE PROGRAM TABLES
B132/B200 5-86 SM
3401 TE Detect Set Detect/No Setting DFU
These SP codes modify the operation of the toner end sensor. Switches toner end off
and on.
[0~1/1] 0:Detect, 1: No Detect
3411 TE Pgs Min:K
Use this SP to set the number of pages to print after the toner near-end alert has been
issued. Once the specified number of pages have printed, the machine issues the
toner-end alert, and the machine will not operate until the toner supply has been
replenished.
Note:
• There are two counters for toner end, page count (003~4) and pixel count
(005~006).
• The toner end alert is issued by whichever limit is exceed first, page count
(003~004) or coverage (005~006).
001 TE Sheets Min:K
002 TE Sheets Min:Col
Sets the minimum number of pages to print (black or color)
after the toner near-end alert until toner end.
[0~50/1]
003 TE Sheets Max:K
004 TE Sheets Max:Col
Sets the maximum number of pages to print (black-and-white,
or full-color) after the toner near-end alert until toner end,
based on page count (regardless of coverage).
[0~1000/1]
005 TE:Pixels:K
006 TE:Pixels:Col
Sets the number of images to print (black-and-white or full-
color) after the toner near-end alert until toner end based on
coverage (30 A4 pages at 100% coverage).
[0~100/1]
007 TNE:Sheets:K
008 TNE:Sheets:Col
Sets the number of times that the toner supply clutch is
activated when toner is low, to detect the toner end condition.
[0~30/1]
To Next Page
Loading...
