COPIER B132/B200
B132/B200 1-14 SM
IMPORTANT!
• DO NOT TRY TO PULL OUT THE DRAWER UNIT UNTIL AFTER YOU REMOVE THE FOLLOWING
RETAINERS.
13. Remove the tape [A].
14. Pull on the reinforced part [B] on tag [C] to remove the stabilizing rod [D].
NOTE: If you do not pull on the reinforced part [B], you will tear the tag or pull
the wire off.
15. Remove the bracket [E], red tag, and wire ( x1).
NOTE: DO NOT REMOVE BRACKET [F].
B132I723.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
