SERVICE PROGRAM TABLES
B132/B200 5-138 SM
6115 Max Prestack Number of Pre-Stack Sheets
This SP sets the number of sheets sent to the pre-stack tray. With this SP set to the
default (3):
• 3 sheets are sent to the pre-stack tray.
• When the 4th sheet feeds, the 4th sheet and 3 sheets from the pre-stack tray
are sent to the stapling tray together.
Note: You may need to adjust this setting or switch it off when feeding thick or slick
paper.
0:None-3:3Shts [0~3/1 sheet]
0: None
1: 1 sheet
2: 2 sheets
3: 3 sheets
6116 Thk Sht Count Thick Sheet Count
This SP sets the number of sheets of normal thickness to count for one thick sheet.
The default (3) counts three sheets of normal thickness for one thick sheet.
[1~3/1]
6117 Allow Tnk Punch Allow Punching of OHP Sheets
This SP allows you to switch on punching of OHP sheets. Normally, OHP sheets
cannot be punched. If this SP is switched on (1), the performance of the finisher cannot
be guaranteed (the sheets may jam).
[0~1/1]
6118 Output Jog On Output Jogger Operation Off/On
This SP switches the jogging operation of the output jogger attached to the side of the
finisher off and on.
[0~1/1] 0: Off, 1: On
Note: After installation of the Output Jogger Unit B703, this SP must be set to "1" for
the jogging motor to operate the jogging fences.
6119 No Z-Fold/Punch Prohibit Z-Folding and Punching Japan Only
Switch Z-folding off and on. Default: 0 (Off)
0:No 1:Yes
6120 Free Run Free Run 1: Post Processing
These SPs set the peripherals list below in the free run mode for testing.
001 Free Run 1 System Free Run Finishers B701/B700, B706
002 Free Run 1 Free Run (Endurance Testing) Finisher B706
003 Free Run 3 Free Run Finishers B760, B468/B469
004 Free Run 4 Shift, Free Run Finisher B706
To Next Page
Loading...
