COPIER B132/B200
SM 1-17 B132/B200
Installation
8. Place the development unit [A] on a clean sheet of A3/DLT paper [B].
9. Remove the screws from the dummy cartridge [B] ( x 2).
10. With a fingernail, release the tabs on the left [C] and right [D].
Important: The development unit is top-heavy and falls easily. Hold it on the
left side.
11. While holding the unit steady with one hand on the left [E], remove the dummy
cartridge [F] from the development unit.
12. Shake the new yellow developer cartridge [G] from side to side about 6 times.
B132I105.WMF
B132I105A.WMF
[A]
[B]
[B]
[C]
[G
[D]
[E]
[F]
To Next Page
Loading...
