COPIER B132/B200
SM 1-19 B132/B200
Installation
17. Check the following to points to be sure that the developer cartridge is set
properly.
• Tabs [A] and [B] should be locked.
• The developer cartridge edge [C] should be flat and not bulging or floating
away from the side of the development unit
• Pull gently on the developer cartridge at [D] to make sure that it does not part
from the development unit.
18. Fasten the cartridge [E] ( x2).
IMPORTANT: DO NOT REMOVE THE FILM SEAL [F] ON THE DEVELOPER CARTRIDGE AT THIS
TIME
.
B132I106B.WMF
B132I106C.WMF
[A]
[B]
[C]
[D]
[F]
[E]
To Next Page
Loading...
