COPIER B132/B200
SM 1-21 B132/B200
Installation
22. Hold the PCU [A] in front of the slot where you
removed it.
23. Engage the rails [B] with the slots in the sides of
the PCU.
24. Slowly push the PCU into the slot. Make sure
the tab [C] above the PCU is locked.
NOTE: If the PCU does not go in smoothly,
make sure the rails [B] and grooves are
engaged correctly.
25. To release the developer into the PCU,
pull out the film seal [D].
NOTE: Put your other hand on the
PCU [E] to keep it stable it while you
pull on the film seal.
26. Repeat Steps 1 to 25 for the other
PCUs (Cyan, Magenta, Black).
B132I114.WMF
B132I905.WMF
B132I101.WMF
[A]
[C]
[D]
[E]
[B]
To Next Page
Loading...
