IMAGE TRANSFER AND PAPER TRANSFER
SM 6-95 B132/B200
Detailed
Descriptions
When Black-and-White Mode is Selected:
• The motor turns the cam until the actuator goes out of the ITB lift sensor.
• The motor stops.
• With the left side of the ITB down, only the black (K) drum contacts the ITB.
• The machine automatically adjusts paper feed timing for black-and-white copying
with only one drum.
• The ITB stays down until the next full-color job starts
When ACS Mode is Selected:
If the job has color pages and black-and-white pages, the ITB operation is
controlled by SP 5880 001.
• The default is 0 (low productivity). In this mode, the ITB changes position each
time the page type changes. This makes printing slower, but decreases wear on
the color PCUs.
• If you set the SP to 1, then the belt will not move away from the color PCUs if a
black-and-white page is next. This makes printing faster, but increases wear on
the color PCUs.
To Next Page
Loading...
