FOLD UNIT
SM 19 B700/B701
2000/3000
Sheet
Finisher
B700/B701
Important: Support the fold unit with your hand to prevent it from falling.
CAUTION: The fold unit is heavy.
[A]: Folding unit ( x4, x2, x6)
If you have replaced the folding unit:
1. Read the DIP SW settings on the decal [B] attached to the back of the new
folding unit.
2. Check the DIP SW settings on the main board [C] of the finisher.
3. If these settings are different, change these settings to match settings printed
on the seal attached to the folding unit.
NOTE: Set DIP switches 1 to 4 (the switch set on the right). Do not touch the
other DIP switches.
B700R124.WMF
B700R134.WMF
[B]
[C]
[A]
To Next Page
Loading...
