Type 5002
(D629)
6. Remove the knockout for LINE 2 from the controller cover.
7. Install the FCU in the machine (for details, refer to Fax Option Installation).
8. Reattach the controller cover (
x2).
9. Connect the telephone cord to the LINE 2 jack.
10. Enter the service mode. Set bit 1 of communication switch 16 to "1" (SP1-104-023) for
PSTN-2.
11. Turn the main switch off and on.
12. Print out the system parameter list. Then check that "G3" shows as an option.
13. Set up and program the items required for PSTN-2 communications.
14. Attach the FCC decal near the serial number plate of the mainframe.
To Next Page
Loading...
