Copy Adjustments: Printing/Scanning
D129/D130 4-116 SM
4.16.4 ADF
Registration
1. Make a temporary test chart as shown above using A3/DLT paper.
2. Place the temporary test chart on the ADF and make a copy from one of the feed stations.
3. Check the registration, and adjust using the following SP modes if necessary.
SP No. Specification
Side-to-side: 1st side SP6-006-1
0.0 mm ±3 mm
Side-to-side: 2nd side SP6-006-2
Leading Edge SP6-006-3 0.0 mm ±5 mm
Leading Edge: 1st side SP6-006-5 0.0 mm ±3 mm
Leading Edge: 2nd side SP6-006-6 0.0 mm ±2.5 mm
Trailing Erase edge: SP6-006-7 0.0 mm ±10.0 mm
Rev. 12/27/2012
To Next Page
Loading...
