EasyManua.ls Logo

Ricoh D129 - Ip-Fax Troubleshooting; Cannot Send by IP Address;Host Name; Ip-Fax Transmission

Ricoh D129
1402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP-Fax Troubleshooting
D629 44 SM
3.3 IP-FAX TROUBLESHOOTING
3.3.1 IP-FAX TRANSMISSION
Cannot send by IP Address/Host Name
Check Point Action
1 LAN cable connected? Check the LAN cable connection.
2 Specified IP address/host name correct? Check the IP address/host name.
3 Firewall/NAT is installed?
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
4 Transmission sent manually? Manual sending not supported.
5 IP address of local machine registered? Register the IP address.
6
Remote terminal port number setting other
than 1720 (when using H.323) or 5060
(when using SIP)?
Send by specifying the port number.
7 Specified port number correct?
Confirm the port number of the remote
fax.
8
DNS server registered when host name
specified?
Contact the network administrator.
9 Remote fax a T.38 terminal?
Check whether the remote fax is a T38
terminal.
10 Remote fax switched off or busy?
Check that the remote fax is switched
on.
11 Network bandwidth too narrow?
Request the network administrator to
increase the bandwidth.
Raise the delay level.
IPFAX SW 01 Bit 0 to 3

Table of Contents

Other manuals for Ricoh D129

Related product manuals