Main Machine Installation
D129/D130 2-10 SM
10. Attach the correct brand decal to the machine [A].
11. Attach the correct emblem and the cover to the front door [B] of the machine, if the emblem
is not attached.
If you want to change the emblem that has been already attached, remove the
panel with a small screwdriver, and then install the correct emblem.
12. Attach the correct paper tray number and size decals to the paper trays [C].
13. Pull out the feeler [A] for the output tray full detection mechanism.
PCDU (Photoconductor and Development Unit)
1. Open the front door.
2. Open the right door [1].
3. Release the lock lever [2].
4. Pull out the PCDU [3] and place it on a clean flat surface.
5. Spread a large piece of paper on a flat surface.
To Next Page
Loading...
