Copy Adjustments: Printing/Scanning
D129/D130 4-114 SM
4.16.3 SCANNING
Before doing the following scanner adjustments, perform or check the printing
registration/side-to-side adjustment and the blank margin adjustment.
Use the S5S test chart to perform the following adjustments.
Registration: Platen Mode
1. Place the test chart on the exposure glass and make a copy from one of the feed stations.
2. Check the leading edge [A] and side-to-side [B] registration, and adjust them with the
following SP modes if necessary.
SP No. Specification
Leading Edge SP4-010-1 0 ±2.0 mm
Side-to-side SP4-011-1 0 ±2.5 mm
Rev. 12/27/2012
To Next Page
Loading...
