Ricoh D129 - Reassembling the Rear Scanner Wire

Scanner
D129/D130 4-30 SM
Reassembling the Rear Scanner Wire
1. Position the center ball [B] in the middle of the forked holder.
2. Pass the end with the ball [A] through the right square hole from the front.
3. Position the center ball [B] in the middle of the notch, as shown by the arrow.
4. Pass the ball end [A] through the drive pulley notch.
5. Wind the end with the ring [C] clockwise (shown from the machine’s front) three times; wind
the ball end [A] clockwise (shown from the machine’s front) five times.
 The two red marks [D] should meet when you have done this.
6. Stick the wire to the pulley with tape, so you can easily handle the pulley and wire during
installation.
7. Install the drive pulley on the shaft.
 Do not screw the pulley onto the shaft yet.
8. Install the wire.
 The winding of the wire on the three pulleys at the rear of the scanner should be
the same as the winding on the three pulleys at the front. This must show as a
mirror image. Example: At the front of the machine, the side of the drive pulley with
the three windings must face the front of the machine. At the rear of the machine, it
must face the rear.
9. Perform steps 8 through 13 in “Reassembling the Front Scanner Wire”.
 After replacing the scanner wire, do the image adjustments in the following section
of the manual (
"Scanning" in "Copy Adjustments: Printing/Scanning").