Tables
Error Messages
An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows error "E24"
displayed. For details, refer to the Error Message Table. (
"Handling Firmware Update
Errors" in this section)
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during the update
because the module selected for update was not on the SD card.
Recovery after Power Loss
If the ROM update is interrupted as a result of accidental loss of power while the firmware is
updating, then the correct operation of the machine cannot be guaranteed after the machine is
switched on again. If the ROM update does not complete successfully for any reason, then in
order to ensure the correct operation of the machine, the ROM update error will continue to
show until the ROM is updated successfully.
In this case, insert the card again and switch on the machine to continue the firmware download
automatically from the card without the menu display.
To Next Page
Loading...
