Updating the Firmware
D129/D130 5-214 SM
To remove the SD, push it in to unlock the spring lock. Then release it so it pops
out of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update screen
appears on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the operation
panel to select the item in the menu that you want to update.
ROM/NEW What it means
ROM:
Tells you the number of the module and name of the version
currently installed. The first line is the module number, the second
line the version name.
NEW:
Tells you the number of the module and name version on the SD
card. The first line is the module number, the second line the
version name.
Controller, engine and operation panel firmware cannot be updated at the same
time. It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or
) to start the update.
While downloading is in progress, the LCD will display "Loading". When
downloading has been completed, the panel will display "update done".
For operation panel software, the Start key lights red while downloading is in
progress, and then lights green again after downloading is completed.
9. The "Update is Done" message appears on the operation panel after completing the
updating. The message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or
follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.
To Next Page
Loading...
