Ricoh D129 - Installation Procedure

Bridge Unit Installation (D634)
SM 2-37 D129/D130
Installation
2.9.2 INSTALLATION PROCEDURE
 Unplug the copier power cord before starting the following procedure.
 If you will install the 1-bin tray (D632) on the machine, install the 1-bin tray first before
installing the bridge unit (D634). This makes it easy to do the following procedure.
 If you will install the finisher unit (D588, D636 or D637) on the machine, install it after
installing the bridge unit (D634).
1. Remove all tapes.
2. If the sensor feeler [A] is out, fold it into the machine.
3. Open the right door of the machine.
4. Remove the upper inner tray [A].
5. Remove the front right cover [B] (
x 1).
6. Remove the connector cover [C] (
x 1).