Ricoh D129 - Preparation; Updating Firmware; Updating Procedure

Updating the Firmware
SM 5-213 D129/D130
Service
Tables
5.12.2 UPDATING FIRMWARE
Preparation
1. If the SD card is blank, copy the entire "romdata" folder onto the SD card.
2. If the card already contains the "romdata" folder, copy the "D129" folder onto the card.
Updating Procedure
1. Turn the main power switch off.
2. Remove the controller cover ( x 2).
3. Insert the SD card into SD Card Slot 2 (Lower Slot) [A]. Make sure the label on the SD card
faces the rear side of the machine.
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure
the SD card locks in place.