2.11.2 INSTALLATION PROCEDURE
Unplug the main machine power cord before starting the following procedure. If the
2000/3000-sheet booklet finisher has been installed, disconnect it and pull it away from
the machine.
1. Remove all tapes and shipping retainers.
2. If the finisher is connected to the copier, disconnect the power connector [A] and separate
the finisher from the copier.
3. Remove the rear cover [B] (
x 2) and open the front door.
At the base of the back cover, be sure to disconnect the tabs that fasten the cover
to the frame.
4. Remove the guide plate [C] (
x 2).
To Next Page
Loading...
