Scanner
D129/D130 4-26 SM
8. Front scanner wire clamp [A]
9. Front scanner wire bracket [B] (
x 1)
10. Front scanner wire and scanner drive pulley [C] (
x 1)
Reassembling the Front Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the right end (with the ball) [B] through the square hole. Pass the left end (with the
ring) [C] through the notch.
3. Wind the right end counterclockwise (shown from the machine’s front) five times. Wind the
left end clockwise twice.
The two red marks [D] come together when you have done this. Stick the wire to
the pulley with tape. This lets you easily handle the assembly at the time of
installation.
To Next Page
Loading...
