and
Adjustment
4. Install the drive pulley on the shaft [E].
Do not attach the pulley to the shaft with the screw at this time.
5. Insert the left end into the slit [F]. The end should go via the rear track of the left pulley [G]
and the rear track of the movable pulley [H].
6. Hook the right end onto the front scanner wire bracket [I]. The end should go via the front
track of the right pulley [J] and the front track of the movable pulley [K].
Do not attach the scanner wire bracket with the screw at this time.
To Next Page
Loading...
